Now fish the wire up to the headlight area. This works better if you remove the headlight first. Take the bulbs out of the lens. The green/white wire is the flasher, the yellow/white is courtesy and black is ground (not used here). Connect one new lead wire to each of the flasher wires. Install the inline connectors, tape them up and replace the headlight. For more info on how the wiring works see this link:
http://www.danielsternlighting.com/t...rkerflash.html
Before you put the mirror or headlight on test the lights out. To replace the mirror, tilt the carrier outbound. Reconnect the defrost connections. While holding the glass in the housing along the inboard side, line up the four tabs with the slots then at the same time, push slightly in against the mirror and outboard. The mirror will click when fully engaged. This is what you should end up with.
