Blower issue with a/c...help please
#1
Blower issue with a/c...help please
I need some help I am working on my 99 dodge ram 1500 van. The blower for the a/c only works on full blast the first three settings do not work. I replaced the switch (best way to describe it) on the air box under the hood which contains the coils and resistors and it worked briefly. I also replaced the relay attached to the air box as well thinking that may be the problem. im out of ideas short of buying a new blower motor, any help would be appreciated.
#2
The replacement "blower motor resistor pack" may be acting up or blown. Be sure the replacement pack did not go out. Double check the connection to see of any of the wires that connect to the pack look like they have been overheated and/or melted.
Also look for a negative ground wire near the body of the firewall by the HVAC box, make sure it is in good condition. The relay must have a ground in order to activate for the lower speeds. The relay default it set to allow the motor to work on high speed. So if the relay has a bad ground then it cannot trip for the slower speeds.
#4
Then that is where your problem still is. I'm sure if you inspect the connector that goes to the resistor pack (it's not a switch) you will find either burnt or corroded terminals. The dealer sells a repair pigtail kit for this connector.
#5
#6
#7
Trending Topics
#8