When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
From what I'm being told, is that the brushes inside the motor have worn down to the point where they are not longer making the same contact on the windings as they were when it was new. This reduction in contact equates to a reduction in current flowing from the motor slowing it down. It's weak. The only recourse is to replace the brushes or most likely the cheaper route, unless you can do that yourself is to replace it. I found on RockAuto.com the complete motor AND regulator assembly shipped for $70. Not a bad price for new parts.
Thing is, that window that's giving me issues had the motor replaced with a new one, 6 months ago.
It is usually a bad motor or bad master switch. You can unplug the master switch and use a jump wire to raise the window if the motor is good until you get a new switch, if it doesn't raise then you have a bad motor.
yea as i said before the switch panel itself needs to be replaced, not cleaned REPLACED, you could get one in a j/y if you can find one there that matches your truck (or maybe swap the controls to the panel from your truck)
I am having the same issue with Avenger Passenger window...I just hate to buy parts I may not need. Someone mentioned the "regulator" in the window?????
I am having the same issue with Avenger Passenger window...I just hate to buy parts I may not need. Someone mentioned the "regulator" in the window?????
If your having an issue with the power window on an Avenger you'd be better off posting your question in the avenger section, since the parts are most likely way different between the Durango and the Avenger.
I have a 2004 Durango, the rear passenger window will go down, but not up from its own door switch. It will go up, and down, no problem from the drivers side master switch..........so, my questions is: What do I check to see why it won't go up from its own door switch? I don't think it would be the motor because it goes up and down no problem from the divers side. I would like to fix it my self? please help!!!