1999 dodge durango will turn over but wont start! please help
#1
1999 dodge durango will turn over but wont start! please help
I just bought my first vehicle which is the 99 dodge durango about 6 months ago and it was used. it ran PERFECTLY fine up until a month ago, out of no where while i was driving the engine cut off and the odometer read "no bu5". i tried jump starting it (didnt work) i tried taking out the key and turing it over(WHICH IT STILL DOES TO THIS DAY) didnt work. i keep the battery charged so i have no problem trying to start it but what i dont get is that it will turn over evrytime i try but just wont start up. ive checked ALL the fuses that i know of which is under the hood and on the side of the dashboard and there ALL still good, none burnt out. im not that mechanically inclined so im looking for the all the help i can get.
Last edited by aloc107211; 10-10-2012 at 01:20 AM. Reason: desperate on getting help
#3
#4
#6
#7
ok i found it. I wiggled the wires to see if its the connectors and nothing seemed to happen. then i tried the 3 key sequence and it didnt show any code except the no bu5 after i stopped the sequence. i did notice that the "FUEL GAUGE" is not moving at all. would that cause the dash to say "no bu5"?>>>>>did the new pcm fix your problem{littlelady}?
Last edited by aloc107211; 10-10-2012 at 08:38 PM.
Trending Topics
#8
#9
if the PCM isnt communicating properly you get the no bus error in the odometer window, if the PCM is not communicating the keydance trick will not work because it is just pulling the codes from (surprise surprise) the PCM.
your issue is one of two things, a bad PCM or bad connection to the PCM
your issue is one of two things, a bad PCM or bad connection to the PCM
#10