Hey guys, I hear you need a special puller to take the front crank pulley off a 96 3.3L because there is no holes to thread bolts in? My gf's intrepid is a 96 3.3L obviously with 130,000KM on it (about 81250 Miles). There is a lot of oil under the car, all over the pan etc. It looses about 1 litre of oil per 5000km oil change, there is oil around the crank seal, so I will start by changing it. Any pointers? and do I need the special pulley? Looks like the rad has to come out, no big deal. Thanks in advance.
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on Dodge Forums!
__________________
94 Ram 4x4 318. Replace your muffler with a hollow pipe! Wanting to do a hat top air intake and scoop my hood, covering up with pantyhose while boggin. Tall Narrow Mud Terrains, Cobra 29 cb, 4 inch tach etc. etc. I'm from Canada, drive through 6 feet of fresh snow every morning and I DO know JOE!
Sponsored Links
Registered users do not see this ad. Click here to register for free!
Hey guys, I hear you need a special puller to take the front crank pulley off a 96 3.3L because there is no holes to thread bolts in? My gf's intrepid is a 96 3.3L obviously with 130,000KM on it (about 81250 Miles). There is a lot of oil under the car, all over the pan etc. It looses about 1 litre of oil per 5000km oil change, there is oil around the crank seal, so I will start by changing it. Any pointers? and do I need the special pulley? Looks like the rad has to come out, no big deal. Thanks in advance.
this tool is the ticket, just pull rad support, pull fans and crank bolt. idk if the zone rents them but yall culd check
1996 3.3L Crank Pulley Removal Leaking Oil
