Consensus on Fuel Pump replacement - drop tank or lift bed?
#1
#2
BTDT, LIFT THE BED. lol. I by no means am that good when it comes to repairs since I am still learning, and when we worked on the fuel pump we lifted the bed. 8 bolts, 3 screws, an electrical harness connector and it's ready to come off.
#3
I dunno man, I guess if I had to do it all over again, I would take the amount of gas in the tank into consideration. I had just filled the tank when mine went. What a PITA getting the gas out and into containers. 20 some gallons of gas is more than you would think. If I took that into consideration, I probably would have lifted the bed. On the other hand, if there is very little or no gas in the tank, it's not that bad to remove the tank, do the pump and put it back up. When it comes down to it I guess it's your call. Good luck, I am doing a fuel pump in my kids Saturn tonight. Same thing, a freshly full tank of gas, only this time I bought a power siphon to pump the gas into my truck, then I will drop the tank hehe.
#5
If you have an impact wrench, pneumatic or electric, it's easier to spin the bed bolts off...even if you're alone. Then you scoot the bed back, replace the pump and reverse the procedure. I hate laying on my back fighting rusty, stuck fasteners like those on the tank straps. Just keep the bed fairly square if decide not to lift it off, then you just have to scoot it back in place after you finish the pump.
#6
#7
Trending Topics
#9
http://home.fuse.net/pieper/2010-07-24%2008.55.46.jpg
Thanks for the replies, lifted the bed, job done in 90 minutes, decided to do rear shocks at the same time, too easy with the bed off.
Thanks again,
Ron
Thanks for the replies, lifted the bed, job done in 90 minutes, decided to do rear shocks at the same time, too easy with the bed off.
Thanks again,
Ron
Last edited by 16Victor; 07-24-2010 at 12:47 PM. Reason: added link