2003 Caravan 3.3L heating problem
#1
2003 Caravan 3.3L heating problem
I have an 03 3.3L Grand Caravan Sport. The van takes for ever to warm up and sometimes the needle does not move off of the cold mark and only blows cool air into the cabin of the van. The antifreeze is full, the engine is hot, and it never over heats. Most of the time the needle sits between 1/4 or just above on the temp gauge. Any suggestions?? Also, I have that headlight flickering problem. There are no error codes on the van.
#4
lights flickering
I have an 03 3.3L Grand Caravan Sport. The van takes for ever to warm up and sometimes the needle does not move off of the cold mark and only blows cool air into the cabin of the van. The antifreeze is full, the engine is hot, and it never over heats. Most of the time the needle sits between 1/4 or just above on the temp gauge. Any suggestions?? Also, I have that headlight flickering problem. There are no error codes on the van.
#5
Hey jaykid... any updates or resolutions to your "no heat" problem? I have an '03 T & C, 3.8L, with the same problem. I've replaced 2 thermostats in last 2 days, thinking the first replacement was defective. At any rate, temp gauge still doesn't move much higher than the 1/4 mark. Really sounds like I'm having the exact same problem minus the flickering lights.
Last edited by hopsluvr; 01-14-2011 at 03:39 PM.
#6
Heating problem
I haven't tried replacing the ECM as per the last suggestion, however, I noticed that when I replaced my air filter, did an oil change(I added Lucas additive) the issue seems to have gone away. Wewill see how it goes. I have been told that if I take the van in to a dodge service center they can reset my computer in the car and that may fix my problem. The issue withthe flickering lights turned out to be a faulty headlight switch.
Hey jaykid... any updates or resolutions to your "no heat" problem? I have an '03 T & C, 3.8L, with the same problem. I've replaced 2 thermostats in last 2 days, thinking the first replacement was defective. At any rate, temp gauge still doesn't move much higher than the 1/4 mark. Really sounds like I'm having the exact same problem minus the flickering lights.