Axle Swap- Turning my 1500 into a 2500
#1
Axle Swap- Turning my 1500 into a 2500
I'm getting ready to turn my 1999 1500 into a 2500 with parts from a 1996 and I understand swapping the front axle is no problem and everything fits. I was originally told the back would bolt right in too, but I found a few people that said it will not and that the U-bolts don't match up. I am swapping the 2.5in leafs for 3in also, will this fix the issue? Another thing I thought would be fine is the drive shaft. Will the shaft from my 1500 work, if not can I just use a 2500 shaft? Last thing someone mentioned is the gear ratios, I am assuming my 1500 and a regular V8 2500 will both have 3:55 gears, am I right about this? Is there anything else that may be an issue between a 96 and 99? Thanks for the help!
Last edited by eggie329; 05-04-2011 at 03:35 AM.
#2
Since you are swaping leafs to the 3in you will need new Ubolts. Gear ratio could be 3.55,3.73or 4.10. Just make sure the front and the rear are the same lol... Your drive shaft from your 2500 will slip into your trans as long as both trucks were autos. The length im not to sure on if anything it will be an inch or two off if at all.
#3
#4
Curious about the rear axle as well. I've read alot of things that say you need to cut off the rear perches and weld on new ones because there is an inch width difference between the 1500 and 2500. However Extreme 4x4 did and episode where they swapped a D60 front and rear out of a 2500 into their same year half ton and said there was NO fabrication needed and it was a direct bolt on. I realize they could easily be full of it being tv and all, but can someone clarify this?
#5
#6
#7
@HeyYou
I understand that if you don't want to re-weld the perches you can notch the existing ones to use the u-bolts on the half ton. This seems to be a common thing from what I've researched. Please elaborate if I am wrong.
@Kraiger
Thanks for clearing that up. I suppose an easy thing for me to do would be to measure. I know my perches are 42in inside to inside. I just haven't put much effort into it because I don't weld and there seemed to be a lot of conflicting reports. My truck is a 2000 Sport Off-Road so I assume that my situation would be identical to yours? That is confidence inspiring because it is an upgrade that I really want to do. The benefits are too much to ignore.
I apologize to the OP for thread jacking.
Thanks guys!
I understand that if you don't want to re-weld the perches you can notch the existing ones to use the u-bolts on the half ton. This seems to be a common thing from what I've researched. Please elaborate if I am wrong.
@Kraiger
Thanks for clearing that up. I suppose an easy thing for me to do would be to measure. I know my perches are 42in inside to inside. I just haven't put much effort into it because I don't weld and there seemed to be a lot of conflicting reports. My truck is a 2000 Sport Off-Road so I assume that my situation would be identical to yours? That is confidence inspiring because it is an upgrade that I really want to do. The benefits are too much to ignore.
I apologize to the OP for thread jacking.
Thanks guys!
Trending Topics
#8
#9