More engine codes 2001 caravan 3.3
#1
More engine codes 2001 caravan 3.3
So my wife called and said the van went into limp mode. Happend a couple years ago and we had to replace a transmission solenoid. Had her get the codes for me. We have the following codes
P1684 - the usual battery code
P1297 - No change in MAP sensor start to run
P0172 - Fuel system rich
P0442/P455 Med/Large Evap leak
P1193 - Inlet air temp voltage high
P0700 - EATX Controller DT present
Would 1297 0172 1193 be solved by replacing the MAP sensor? I cleaned the EGR a while ago and it ran better for a short while, then the hesitations have started again, maybe that needs to go too?
0700 has me completely stumped, but I'm guessing thats why it went into limp mode.
P1684 - the usual battery code
P1297 - No change in MAP sensor start to run
P0172 - Fuel system rich
P0442/P455 Med/Large Evap leak
P1193 - Inlet air temp voltage high
P0700 - EATX Controller DT present
Would 1297 0172 1193 be solved by replacing the MAP sensor? I cleaned the EGR a while ago and it ran better for a short while, then the hesitations have started again, maybe that needs to go too?
0700 has me completely stumped, but I'm guessing thats why it went into limp mode.
#2
#3
First thing? Reset codes and see what comes back. How? Either use a scanner or disconnect the negative battery cable for 2-3 minutes.
P0700 is telling you the TCM (EATX Controller) may have detected a fault and stored a code. Have the TCM code read by a shop with a specialised scanner capable of reading transmission codes.
P0700 is telling you the TCM (EATX Controller) may have detected a fault and stored a code. Have the TCM code read by a shop with a specialised scanner capable of reading transmission codes.
Last edited by Cougar41; 07-03-2011 at 01:55 AM.