How Do I Remove/Replace T&C RF Seat Belt?
#1
#2
SEAT BELT - OUTBOARD FRONT
REMOVAL
- Remove shoulder harness height adjuster **** by pulling it straight away from adjuster.
- Remove cover from seat belt turning loop.
- Remove bolt holding turning loop to shoulder belt height adjuster
- Separate turning loop from B-pillar.
- Remove lower B-pillar trim cover or quarter trim panel on three door left side.
- Remove bolt holding seat belt retractor to B-pillar
- Lift retractor upward and disengage arrow head retainer holding retractor to B-pillar.
- Separate seat belt from vehicle.
Reverse the preceding operation. Tighten seat belt anchor bolts to 39 N·m (29 ft. lbs.)
LOWER B-PILLAR TRIM COVER
REMOVAL
- Slide lower seat belt cover rearward to expose anchor bolt.
- Remove bolt holding lower seat belt anchor to floor.
- Remove upper B-pillar trim cover.
- Remove access panel from B-pillar trim
- Remove screw holding lower trim cover to B-pillar from below seat belt retractor.
- Disengage hidden clips holding lower trim cover to B-pillar.
- Separate lower B-pillar trim cover from vehicle.
- Place lower B-pillar trim cover in position on vehicle.
- Insert seat belt through hole in lower B-pillar trim.
- Engage hidden clips to hold lower trim cover to B-pillar.
- Install screw to hold lower trim cover to B-pillar below seat belt retractor.
- Install access cover.
- Install upper B-pillar trim cover.
- Place seat belt anchor in position on floor so webbing is pointed rearward and slightly outboard.
- Install bolt to hold lower seat belt anchor to floor.
- Verify that seat belt anchor does not interfere with seat track travel.
REMOVAL
- Remove bolt holding lower seat belt anchor to floor.
- Lower shoulder belt height adjuster to the bottom of travel.
- Remove shoulder belt turning loop from height adjuster.
- Using Snap-on® prying tool (A179A), or equivalent, remove shoulder belt height adjuster ****.
- Remove shoulder belt bezel from trim cover.
- Remove screw holding trim cover to B-pillar from inside bezel cavity.
- Disengage hidden clips holding trim cover to B-pillar.
- Separate B-pillar trim cover from vehicle
- Insert seat belt through B-pillar trim and web guide.
- Place B-pillar trim cover in position on vehicle.
- Engage hidden clips to hold trim cover to B-pillar.
- Install screw to hold trim cover to B-pillar inside bezel cavity.
- Install shoulder belt bezel into trim cover.
- Install height adjuster ****.
- Install shoulder belt turning loop onto height adjuster.
- Place seat anchor in position on floor so webbing is pointed rearward and slightly outboard.
- Install bolt to hold lower seat belt anchor to floor.