Transmission input/output speed sensors
#1
Transmission input/output speed sensors
Where are the input/out speed sensors located on an 02 Dodge Grand Caravan EX and is it easy to replace. I'm no automotive specialist by mechanically and extermely common sense inclined. Can I replace myself and is there anything else that I would need to do besides swap out parts?
#2
Input sensor
REMOVAL
Disconnect battery negative cable.
If necessary, disconnect and cap off transmission oil cooler lines.
Disconnect input speed sensor connector.
Unscrew and remove input speed sensor.
Inspect speed sensor O-ring and replace if necessary.
INSTALLATION
Verify O-ring is installed into position.
Install and tighten input speed sensor to27 Nm (20 ft. lbs.) .
Connect speed sensor connector.
Connect battery negative cable.
Look to the right of the transmission fluid dipstick and the sensor is located just below the cooler lines.
The output sensor removal and replacement is exactly the same. I'm assuming that it's on the back side of the transmission where the differential is.
Alldata shows that it is a 1/2 job for each sensor.
REMOVAL
Disconnect battery negative cable.
If necessary, disconnect and cap off transmission oil cooler lines.
Disconnect input speed sensor connector.
Unscrew and remove input speed sensor.
Inspect speed sensor O-ring and replace if necessary.
INSTALLATION
Verify O-ring is installed into position.
Install and tighten input speed sensor to27 Nm (20 ft. lbs.) .
Connect speed sensor connector.
Connect battery negative cable.
Look to the right of the transmission fluid dipstick and the sensor is located just below the cooler lines.
The output sensor removal and replacement is exactly the same. I'm assuming that it's on the back side of the transmission where the differential is.
Alldata shows that it is a 1/2 job for each sensor.
#3
#7
are the wiring repairs simple? Are they on the pigtail side or sensor side? I'm about to drive 1.5 hours tomorrow to get a Caravan with no speedo, no shifting out of "1st" (though it may be 2nd) and the guy says it needs a new speed sensor. I'm thinking it may be a loose wire.
edit: I just noticed this is a 2010 thread. Apologies for exhuming it. Any info would still be appreciated.
edit: I just noticed this is a 2010 thread. Apologies for exhuming it. Any info would still be appreciated.
Trending Topics
#9