When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
3rd Gen Ram Tech2002-2008 Rams: This section is for TECHNICAL discussions only, that involve the 2002 through 2008 Rams Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
After some of the research I've done as to the wheel bearing replacement on the front of my truck......I have some comments that say it goes real smooth, pop the axle out yadda, yadda.
Other comments suggest that the control arm gets in the way and it too needs to be moved.
Is the CV joint really that collapsible on these axles?
Anything else I should know?
Of course some of the vids make it look a little TOO easy....it's the video comments I like to read.
And most seem to have a full lift rather that jackstands.
anti seize the hub/spindle once you get the wheel bearing out .and yes on these truck the axle's do seize in the bearing's i have had to heat up and drive the axle out with air hammer.i pop the upper ball joint off the spindle to get at the whell bearing bolts much easy ier