torsion key and bar dakota 2001
04-16-2014, 06:28 PM
Registered User
Thread Starter
Join Date: Jan 2014
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
torsion key and bar dakota 2001
To just unbolt my 2 torsion key and The 2 shox to install new torsion key and shox that give 3 inche lift but how could i remove the key from the bar or The bar from my lower control arm because it don't go down enough To allow my key to go out of The cross member. Does i need to remove The sway bar to allow my control arm to go down?
04-18-2014, 08:24 PM
Section Moderator
Dodge Forum Moderator
Join Date: May 2012
Location: Concord, CA
Posts: 1,564
Likes: 0
Pry the end of the torsion bar down far enough to get the key off, then block it there with a piece of wood while you work. You'll need a pretty big prybar.
05-05-2014, 01:52 PM
Registered User
Thread Starter
Join Date: Jan 2014
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Thnx Tom.A that's what i finaly do
05-05-2014, 08:39 PM
Section Moderator
Dodge Forum Moderator
Join Date: May 2012
Location: Concord, CA
Posts: 1,564
Likes: 0
Cool. Glad it worked out.