redneck_rams 360 build thread
#281
#282
#283
#284
I connected mine with an "add a fuse" in the fude box below A Pillar. Cannot recall whcih circuit. Minimal current draw on those.
(Looking good!)
#285
installed my new to me fuel injectors that i got from zman. beginning to prep the motor for install. still need to get a thermostat, and gasket. then its all about swapping parts from the 318, to the 360.
oil psi switch, ckps, coil, and all the accessories. gonna be fun!
tear down is thursday/friday. motor is going in sunday!
oil psi switch, ckps, coil, and all the accessories. gonna be fun!
tear down is thursday/friday. motor is going in sunday!
#287
installed my new to me fuel injectors that i got from zman. beginning to prep the motor for install. still need to get a thermostat, and gasket. then its all about swapping parts from the 318, to the 360.
oil psi switch, ckps, coil, and all the accessories. gonna be fun!
tear down is thursday/friday. motor is going in sunday!
oil psi switch, ckps, coil, and all the accessories. gonna be fun!
tear down is thursday/friday. motor is going in sunday!
Good job on the gauges. I've been meaning to get the pod like that b/c of the itty bitty tweetah. Newman linked me to it. Where'd you get that one since I probably missed your post about it.
#288
http://www.glowshiftdirect.com/98-02...illar-Pod.aspx
i ended up leaving the factory pillar cover off. not enough room lol. few to many wires. ill figure a way to attach it to the pillar at some point, for now it hasnt moved an inch.
#290
and i wasnt exactly easy on the truck when i did it... there are now 4" ruts in my yard from my truck sinking lol.
like i said it hasnt moved an inch. gonna get a nutsert or something similar and use that to attach the pod to the pillar. it definitely fits better without the factory pillar cover behind the pod.