When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Go buy a new key, I have tried that welding trick before, the weld will eventually crack and break off the key. Then where will that welded piece end up?
Did your weld come apart? It's a tight interference fit so even if it did break I don't think it could go anywhere. Plus the cam bolt is covering it. I couldn't find a replacement key anywhere and the stock key didn't have any signs of wear so even if I did source a new key I think I would have the same problem.
I got some more stuff in the mail and mounted the heads and put the lifters in. Can't do anymore on the engine until I order a couple more parts, but I can work on the exhaust and get the cai mounted I got from tincan with the gasket that came. My spark plugs I got say small engine on them but they are the right part number. Will they work?
Put in my pushrods and put on the rockers. Also put in the front cover seal and new cam key and I got the last of my parts in the mail except my reflex header gaskets which are m.i.a.
Last edited by snowboundrmk; 05-03-2014 at 10:11 PM.