You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
so from what i've read the nut size for the front hubs on a 2001 4x4 is 1 11/16 but this does nothing for me as i have a 4x2. i went to the dealer and they pulled my VIN and gave me a hub nut based on that VIN. i measured the nut with a tape measure and it was about 1 5/16 is this supposed to be right? like i said i've found nothing about a 4x2 hub nut size.
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on Dodge Forums!
Why don't you just try it? A 4wd uses the large one and on some later models the 2wd uses the same hub bearing assembly as the 4wd. And some 2wd's have the traditional inner/outer replaceable bearings. You are just going to have to look.
__________________
2000 2500HD 4X4 5.9 and 4:10's,HF tuned SCT,Red-Head gear box, HS 1.7's,
50mm Fastman TB, Hughes Plate,2" Hell Bent ,Volant CAI
Flowmaster 50 series, Rock Solid Ram Steering fix,B&M trans cooler
I'm not sure. I need to find out for mine as well cause I have a bearing that needs to be replaced. I think a search on bearing install might find something but haven't looked yet.
hub nut size questions
