You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Thanks! Did you have to replace anything else? Or just bolt those bad boys up?
Here is the DIY courtesy of Iwhitne... I talked to him about them, going to be one of my future mods for sure!! Keep us posted how your install goes and what you think. Good Luck...
That had better be the right ones because that's what I put in my engine.
Someone mentioned a website that you can get them for something like 275$ so wait on them to see this thread before you buy.
__________________
Airgap. HS 1.7s. 50mm DIY TB. SC 3815. 14x2. 4.10 Yukons. Detroit Truetrac-both axles. Front hitch. Rear hitch lights with skid plates. 4 100w off road lights in brush guard. 2 55w lights in front bumper. Westin brush guard/nerf bars. 33" Treadwrights.
ya, it does help the sound of a lil lope of the motor, when i had my cutout open all the time i always got asked at red light and stuff if my truck has a cam.
__________________ [http://www.youtube.com/watch?v=lrw1X3RzulI SCT TUNED! ! ! edelbrock airgap FI, Pacetter Longtubes, 1.7 HS,52mm Fastman, K&N moapr round ,Magnaflow Cats,Cherrybomb Extreme. saving for my 4.10 next
Harland Sharp 1.7 Part # S70037?
[/IMG]
[
