2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

5.2 engine troubles

Thread Tools
 
Search this Thread
 
  #1  
Old 03-12-2011, 12:11 AM
DirtRider1357's Avatar
DirtRider1357
DirtRider1357 is offline
Amateur
Thread Starter
Join Date: Oct 2010
Posts: 43
Likes: 0
Received 0 Likes on 0 Posts
Default 5.2 engine troubles

I have a 1997 ram 1500 extended cab, short bed, 4x4 with the 5.2 and a 5 speed. Ill start off by saying that this truck is SLOW, compared to similar rams with the 5.2. A few days ago i fixed my plenum leak and swapped my cat for a magnaflow one and this truck is still just as slow. Also, when i come to a stop and rev the motor while in neutral, my rpms either drop to about 100 rpms then it returns to idling fine, or my motor just stalls. any ideas on what is causing these problems? thanks
 
  #2  
Old 03-12-2011, 12:14 AM
bcertain's Avatar
bcertain
bcertain is offline
Amateur
Join Date: Nov 2006
Location: Little Elm, TX
Posts: 35
Received 0 Likes on 0 Posts
Default

Start with the easy and less expensive causes firts. New plugs, wires, cap, rotor. Check for vacuum leaks. Fuel filter. Clean throttle body.

Is it throwing any codes? Good Luck.
 
  #3  
Old 03-12-2011, 12:28 AM
DirtRider1357's Avatar
DirtRider1357
DirtRider1357 is offline
Amateur
Thread Starter
Join Date: Oct 2010
Posts: 43
Likes: 0
Received 0 Likes on 0 Posts
Default

thanks but ive already done all that except for the fuel filter and nope no codes.
 
  #4  
Old 03-12-2011, 12:52 AM
J415's Avatar
J415
J415 is offline
Champion
Join Date: Feb 2009
Location: Bay Area, CA
Posts: 3,416
Likes: 0
Received 3 Likes on 3 Posts
Default

The fuel filters on these truck are built into the fuel pumps. Try cleaning you IAC. that might help you issue with it dropping 100 rpms.
 
  #5  
Old 03-12-2011, 02:56 AM
dodgeram07's Avatar
dodgeram07
dodgeram07 is offline
Champion
Join Date: Mar 2008
Location: ohio
Posts: 3,363
Likes: 0
Received 1 Like on 1 Post
Default

Death flash? Maybe.... Go and look at you PCM and see if there is a sticker on it that has hand writing or anything about up dated soft ware
 
  #6  
Old 03-12-2011, 08:15 AM
BIGBIRD85's Avatar
BIGBIRD85
BIGBIRD85 is offline
Veteran
Join Date: Jan 2011
Location: douglasville, ga
Posts: 304
Likes: 0
Received 0 Likes on 0 Posts
Default

SCT TUNER!!!!!!!!!! my truck did that till i did the tuner.
 
  #7  
Old 03-14-2011, 04:31 PM
DirtRider1357's Avatar
DirtRider1357
DirtRider1357 is offline
Amateur
Thread Starter
Join Date: Oct 2010
Posts: 43
Likes: 0
Received 0 Likes on 0 Posts
Default

bump!
 
  #8  
Old 03-14-2011, 06:13 PM
HeyYou's Avatar
HeyYou
HeyYou is offline
Administrator
Dodge Forum Administrator
Join Date: Apr 2010
Location: Clayton MI
Posts: 80,748
Likes: 0
Received 3,176 Likes on 2,929 Posts
Default

How many miles on the truck? I know just changing my timing chain and gears (167K miles) made a noticeable difference in power, and the way the truck ran.
 
  #9  
Old 03-14-2011, 06:18 PM
thetypezero's Avatar
thetypezero
thetypezero is offline
Rookie
Join Date: Mar 2008
Location: Music City
Posts: 76
Likes: 0
Received 0 Likes on 0 Posts
Default

Hows your oil pressure? Had a similar problem with a bad oil pump. I'm not a master mechanic, Just adding my .2
 
  #10  
Old 03-15-2011, 10:06 PM
dhvaughan's Avatar
dhvaughan
dhvaughan is offline
Hall Of Fame
Join Date: Jul 2006
Location: Gainesville, Ga.
Posts: 12,204
Likes: 0
Received 8 Likes on 8 Posts
Default

if there's no other problems like vac leak or needing a tune up, then idle problems are usually caused by IAC (or dirty IAC port) or TPS. they're about $40-50 each at any parts store. clean the old IAC pintle and port first. don't push, pull, or twist the pintle or you'll break it.
 


Quick Reply: 5.2 engine troubles



All times are GMT -4. The time now is 01:20 PM.