You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Just wondering what is the easiest way to get the crankshaft pos. sensor
out of my truck so that i dont have to waste the 70 bucks for an hour of labor. i looked at it and i know where it is. but its hard to get to. so i was
wondering if what the easiest way of doing this project is?? please and thank you.
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on Dodge Forums!