Still have shift issues
#1
Still have shift issues
1995 ram 5.9 engine. 2wd. Replaced vss sensor on transmission. Tv cable is adjusted properly, tranny fluid has no metal in it.. Truck still refuses to go over 2500 rpm in any gear even if I floor it. Any ideas? Is the tv cable attached somehow on the inside of the tranny as well?
#2
Join Date: Mar 2011
Location: Fredericksburg, Virginia
Posts: 8,914
Likes: 0
Received 2 Likes
on
2 Posts
1995 ram 5.9 engine. 2wd. Replaced vss sensor on transmission. Tv cable is adjusted properly, tranny fluid has no metal in it.. Truck still refuses to go over 2500 rpm in any gear even if I floor it. Any ideas? Is the tv cable attached somehow on the inside of the tranny as well?
#4
#5
what about plenum? has it been fixed?
take a rubber mallet or a hammer and whack the cat a little, i would bet you hear things moving around in it. Mileage on the truck?
You probably need a new cat
Front O2 sensor needs repalced at least, get a Denso as Bosch sensors dont mesh with these trucks.
However none of this matters if the Plenum hasnt been addressed as it will happen all over again
take a rubber mallet or a hammer and whack the cat a little, i would bet you hear things moving around in it. Mileage on the truck?
You probably need a new cat
Front O2 sensor needs repalced at least, get a Denso as Bosch sensors dont mesh with these trucks.
However none of this matters if the Plenum hasnt been addressed as it will happen all over again
#7
Join Date: Mar 2011
Location: Fredericksburg, Virginia
Posts: 8,914
Likes: 0
Received 2 Likes
on
2 Posts
https://dodgeforum.com/forum/2nd-gen...um-thread.html
Even IF the PO did replace the plenum he/she may not have addressed the cat....
Even IF the PO did replace the plenum he/she may not have addressed the cat....