burning oil after pelnum plate repair
#1
burning oil after pelnum plate repair
we just repaired the plenum plate with the huges repair kit and now we still get some blue smoke when going down the road but not quite as bad as before im working on the oil pressure issue changing the pick up tube screen it was clogged putting pan back on tomorrow hope that fixes that problem any ideas on where other oil is buring tho
#2
#4
#6
Changed mine pcv from AA. The most expensive pcv at advanced is $7.99 use code p20 for 20% off
But let us know if you do the comp test what the #'s are.. As for the blue smoke that's making me think pcv, valve seal(s), rings
Last edited by It's Me Patt; 10-01-2014 at 07:03 AM.
#7
Does the smoke go away after a Little while?
Rings are probabbly a lil worn at that point. But your valve seals are likely gone. I know i burn a decent amount of oil after start up and the engine has been sitting for a while. But it clears up and then doesn't seem to burn any at all.
If you're having oil pressure problems it seems to point to your bottom end on its way out.
Rings are probabbly a lil worn at that point. But your valve seals are likely gone. I know i burn a decent amount of oil after start up and the engine has been sitting for a while. But it clears up and then doesn't seem to burn any at all.
If you're having oil pressure problems it seems to point to your bottom end on its way out.