RE: no spark 98 dodge ram 318
Managed to get the old crankshaft position sensor removed....It looked fine. I compared the resitance of the old and new. They were the same. I installed a new one.
As I said ealier new OEM coil.
Mew rotor and button and wires were new 3 months back.
I still have no fire, she will not crank.
Just turns over normally...I am charging the battery at night.
I do not get the 5 vdc-o when rotating the motor...nothing with either crank position sensor.
I suspect something further up stream, always did, but all the fuses check ok. All of them
THe ASD relay has 12v however I am wondering why I get a negative 12vdc from all the sockets; with power; to ground. Put my Fluke + lead on the battery negative and +12vdc. Seems wrong but I do not know much.
Bought a ob-2 code reader and there is no codes....I killed the battery positive for a few hours.
My reader does show yellow problem...do not know what that really means either....can't read anything maybe?
Every other function on the truck works...that I can check..lights, bells, locks, windows etc. Fuel pump whirs.
I continue to be lost with a dead truck. My only transportation.
Please help. This week is going to be hard to make work.
By the way I have a little 1/4 and 3/8 Craftsman socket set in the truck for emegencies.
I have 1/4 through 3/4 socket sets in Proto I use for auto when my air tools will not work.
I bought a little Stanley 3/8" rotator ratchet. This was the ticket for removing those crakshaft sensor bolts. It works like a normal socket wrench then you can turn the handle to rotate the drive too.
Dumb struck Michael