Hello All my Fellow Gear Heads......Its time for sounding off......I spent allot of hours tring to figure out what type of pipes I wanted for my truck and with the performance in mind sound came later. So I thought what the heck..Lets start a thread that is all about your pipes.....In your post it should include intake type(Stock,Airrade,K&N,Etc etc)Cat typeie(Stock, MagnaFlow,Etc) Same goes true with your muffler( Stock, Flowmaster, Etc etc) and of course size of motor. And of course how the recording was done (Ie under the truck in the cab etc.....And what it is such as idle rev to ? RPM's etc etc
like this
97 Dodge
5.2L
Airraid Intake
Magnaflow cat
Raven Muffler(Resonator) Single in 2 1/2 inch out to Dual pipes
I've got 2.5in pipes with a single chamber flowmaster. If you've ever seen a single chamber its less than 10 inches long, its very small. My truck is a lot louder than the video shows! I don't have headers yet but thats the next thing I'm gonna do.
nice rich, they sound goood. the only thing i was going to say is that you shouldn't mash down the gas that hard like that without a load on it, you could bend a pushrod.
__________________
2001 CTD 2500. Edge stacked with smarty, bully dog j-hook, air dog raptor 150 with half inch lines, AEM water/Methanol injection, built tranny, banks exhaust turbo back to Silverline 5inch miter cut stainless stacks, 97 dodge ram aka the beast (wheelin rig)
LET ME HEAR YOUR PIPES!!!!!!!!
