2gen Bolt/Nut Size MASTER LIST! YOUR INPUT NEEDED!!!!!! - Page 2

shott8283 · #11 09-13-2006, 05:15 PM

i thought i mentioned that in the first post.. but ill doublle check and make sure i did

ill keep sending it TTT for now untill the list builds up a bit then ill have Tani sticky it and then ill work on a nice layout in either pdf and/or spreadsheet

This ad is not displayed to registered and logged-in members.
Register your free account today and become a member on Dodge Forums!

Ramdamit98 · #12 09-13-2006, 05:49 PM

Quote:

ORIGINAL: shott8283

i thought i mentioned that in the first post.. but ill doublle check and make sure i did

Yes you did shott. My bad. I put my specs for the crankshaft position sensor(V8). I know it's not in the same location for the V10 as for bolt size???

RM_Indy · #13 09-13-2006, 06:53 PM

Good idea, here are a few more to add (1500/5.9/46re)

Crank bolt 32mm or 1 1/4"
Crank pulley 1/2"
Trans hard line brackets to engine 9/16"
Brake line to frame 9/16"
M1/Beerbarrel 1/2"
Water pump 9/16"
AC compressor 1/2"
Rad bolts 10mm
Pwr steering to head 9/16"
Tensioner 9/16"
Alt/AC main bracket 9/16"
Water pump 9/16
Motor mounts to frame 18mm & 21mm
Motor mount to motor 1/2"
Motor to trans 9/16"
Crossbar from motor to trans 1/2" & 5/8"
Starter motor 5/8" deep
Flexplate shield (46re) 7/16"
Oil pan to motor 1/2"
Flexplate to TC 9/16"

Tani1500 · #14 09-13-2006, 07:01 PM

sweet this is coming out awsome, im gunna sticky it in alittle, if we let it free float alot more people will see it.

Ram_Sport · #15 09-13-2006, 07:14 PM

Tail light - T20 Torx drive

Ramsrush · #16 09-13-2006, 07:53 PM

Seatbelt bolts #50 torx bit (95 1500)

The Burning Rom · #17 09-13-2006, 08:03 PM

Quote:

ORIGINAL: shott8283
i thought i mentioned that in the first post.. but ill doublle check and make sure i did

You did, but I was just mentioning it again, since I see a lot of posts with no designations

TMS Bill · #18 09-13-2006, 09:33 PM

ALL Xfer case drain/fill plugs (according to dodgeram.org): 10mm allen

shott8283 · #19 09-14-2006, 12:32 AM

fricken awesome guys!!!! impressive i must say RM!!!! lol TTT for more viewing.. Tani and i will talk when we need to sticky this

shott8283 · #20 09-14-2006, 12:39 AM

Quote:

ORIGINAL: The Burning Rom

Quote:

ORIGINAL: shott8283
i thought i mentioned that in the first post.. but ill doublle check and make sure i did

You did, but I was just mentioning it again, since I see a lot of posts with no designations

sweeet.. yea ill have alot of work after we close it and finalize it!!!!