4th Gen RAM general discussion/NON-tech This section is for general discussions about your 4th gen RAM. Non tech related RAM threads belong here.

Looking to get 200K 2012 4WD..What should I watch out for?

  #1  
Old 07-13-2014, 01:16 PM
Snowfan's Avatar
Snowfan
Snowfan is offline
Professional
Thread Starter
Join Date: Jul 2013
Location: North of Amarillo
Posts: 142
Likes: 0
Received 0 Likes on 0 Posts
Default Looking to get 200K 2012 4WD..What should I watch out for?

Hi all,

2nd gen longtime Ram owner looking to upgrade to a 2012 Hemi 4x4 with a load of miles on it, in great condition. Buying it cheap, of course. What chronic issues should I be aware of with the drivetrain, interior etc.

How are the Hemis doing into the 2-300,000 mile range?
 
  #2  
Old 07-13-2014, 01:25 PM
TNtech's Avatar
TNtech
TNtech is offline
Site Moderator-Dodge Tech
Dodge Forum Moderator
Join Date: Sep 2010
Location: Nashville, Tennessee
Posts: 3,725
Received 18 Likes on 16 Posts
Default

You shouldn't be so $$deep$$ in it that you will lose money if you have to put an engine in it. Buying a 200K truck, or any car for that matter, is a huge gamble especially if you typically pay someone to do your repairs.
 

Last edited by TNtech; 07-13-2014 at 01:28 PM.
  #3  
Old 07-13-2014, 04:54 PM
Snowfan's Avatar
Snowfan
Snowfan is offline
Professional
Thread Starter
Join Date: Jul 2013
Location: North of Amarillo
Posts: 142
Likes: 0
Received 0 Likes on 0 Posts
Default

I appreciate the info and have the business end of the deal covered.

Was more interested in how ball joints, lifters and interiors were wearing. Stuff like that.
 

Last edited by Snowfan; 07-13-2014 at 04:58 PM.
  #4  
Old 07-14-2014, 09:02 PM
Huntjunkie41's Avatar
Huntjunkie41
Huntjunkie41 is offline
Professional
Join Date: May 2010
Location: Va Beach
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
Default

Front hub assemblies, Ball joints, Tie rods, rotors etc are all things you will or could be replacing soon. Has the trans been flushed during it's previous ownership? Should have been flushed approx three time by now. Has the rear and front dif oil been changed? Should be changed every 50 to 100K depending how truck was used or abused. You could get 300K out of the engine if it was maintained well. Lifters are a weak link in the Hemi. Some have complained about them and others have no issues. I have 92 k on mine and no issues until this week. Drivers Hub is gone. Was it a daily driver or a tow vehicle? Has it ever been off road? A lot of variables.
 
  #5  
Old 08-05-2014, 04:59 PM
Dusty48's Avatar
Dusty48
Dusty48 is offline
Veteran
Join Date: Dec 2011
Location: Rochester, New York
Posts: 318
Received 1 Like on 1 Post
Default

I've seen about seven or eight high mileage Hemis (+150,000 miles) and their owners seem to have had little to no problems with them. Suspension components and electrical issues are the two things that stand out the most. Older Rams (3rd gen) appear to have had issues with the Power Distribution Module with taillight symptoms being somewhat common. One fellow told me the end seals were leaking on his rack, but he also was the one with just over 300K miles. I think four of them said the blend door broke on theirs.


As far as I can tell Hemis don't use oil and the 545RFE transmissions are exceptionally sturdy. None of the guys I've talked to had and tranny problems. A few said they replaced U-joints. One guy said his rear differential failed after 160K or so.


Haven't heard much of anything about 4th gen. Did have the coast down ticking problem on my 2010, but that appears to very rare as my dealer has only had one...me! The only component I replaced on my 2010 after 104,000 miles was a rear taillight assembly because water was getting into it.


Best regards,
Dusty


2014 Ram Big Horn 1500 Quad Cab 2WD, 5.7 Hemi, 8HP70, 3.92 LSD, factory dual exhaust, 20” wheels. Now at: 005200 miles.

 

Last edited by Dusty48; 08-05-2014 at 05:03 PM.
  #6  
Old 08-06-2014, 02:38 PM
Snowfan's Avatar
Snowfan
Snowfan is offline
Professional
Thread Starter
Join Date: Jul 2013
Location: North of Amarillo
Posts: 142
Likes: 0
Received 0 Likes on 0 Posts
Default

Thanks Dusty, TNtech and Huntjunkie.

I decided to pass on the truck. My 01 Cummins is loud and rough but will last a long time still. Choosing to get a nice car/suv for my wife instead of the truck. Thanks for the input.

The truck was an escort for oversize/heavy haulers and has had some engine work, notably new lifters. Still has a cyl 2 misfire/mds problem so that tipped me over the edge towards a different rig.
 


Thread Tools
Search this Thread
Quick Reply: Looking to get 200K 2012 4WD..What should I watch out for?



All times are GMT -4. The time now is 11:47 AM.