02 Ram 1500 tcc solenoid dtc
01-16-2017, 07:07 AM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
02 Ram 1500 tcc solenoid dtc
Truck got the dtc for the tcc solenoid, it started stalling at stops, if I'm sitting still in gear with foot on brake, and give a little gas the rims fluctuate while holding steady on accelerator then dies after letting off gas.
01-16-2017, 03:05 PM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Guess my torque converter is locked and when I'm coming to a stop it stalls, the torque converter lock up solenoid is bad
01-16-2017, 06:00 PM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Just found out my tranny has 15 bolts which makes it the 45RFE, looks like these have a solenoid block which is everything built into one, also says there is an updated block with a white plug that replaces mine , is this the same solenoid that controls everything?
01-17-2017, 09:34 AM
Join Date: Jan 2006
Location: White Lake, Mi
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
Check your Transmission fluid at normal operating temp. If it is low, it will stall out when stopping. I just had this issue and discovered when I changed the fluid, I didn't fill it all the way. I should have checked the level after letting it sit for a spell after refilling.
01-18-2017, 06:41 AM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Did it give you a cel? It has to be in neutral also correct?
01-18-2017, 10:28 AM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
01-19-2017, 05:45 AM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
Also if I would go out in the morning and start my truck to let it warm up, when I get ready to leave and put it in gear it kicks in kinda hard
01-19-2017, 05:57 AM
Join Date: Jan 2006
Location: White Lake, Mi
Posts: 176
Likes: 0
Received 0 Likes
on
0 Posts
I did not get a code, it was just stalling.
01-19-2017, 06:31 AM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
I got a code for torque converter clutch solenoid
01-19-2017, 08:31 PM
Professional
Thread Starter
Join Date: Aug 2012
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
How low was your fluid? Mine is about 1/2 inch from the top hole on the dipstick