You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
4th Gen Ram Tech2009+ and up Rams: This section is for TECHNICAL discussions only, that involve the 2009 and up Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
been looking around for awhile but i can't find any information about the connectors that seem to be in a few places, they have a red slider but i can't tell if you have to push in something after you slide it or they just pull out. anybody up on this? thanks
This ad is not displayed to registered and logged-in members. Register your free account today and become a member on Dodge Forums!
[SIGPIC]2009 Ram Hemi RCSB 4x4 , k&n airbox, SC Cortex, fan delete, all synthetic, grounded TB
they should slide away form the sensor or whatever theyre plugged into to unlock and then it should just pull out, might need to use a little pressure on it, at least thats all i needed for the intake temp sensor when i did my CAI
2011 ram 1500 outdoorsman flowmaster super 44, visionx extreme white headlights, K&N CAI
Not exactly. If it's like the plug on the sensor in the intake hose above the engine it is on the same side of the plug as the red slide lock, just further back from the slide tab. If yours doesn't look like that just try squeezing around on the plug (same end with the lock) and you should be able to tell when something moves.