How to remove dash/console/radio on Nitro?
#1
How to remove dash/console/radio on Nitro?
I am installing a Serius Sat radio (plug-n-play on top of the dash type) in my Nitro and want to run my cables through the dash. I can't figure out, however, how to get the dash apart.
I would love to see what is behing my stock radio, as well.
How do I take apart the dash/console on the Nitro!?
Kent!
I would love to see what is behing my stock radio, as well.
How do I take apart the dash/console on the Nitro!?
Kent!
#2
RE: How to remove dash/console/radio on Nitro?
Look on the sides of the dash where the dash and the door meet. Usually theres a panel that can be removed. That starts it with the screws in there. Also try looking in the windsheild air vents. And also underneath the dash and in the glove-box. Those are normal places for screws on a Dodge/plymouth vehicle
#3
RE: How to remove dash/console/radio on Nitro?
Top of dash center take out rubber mat remove two screws , pull up from back then out. Then take bezal from top & pull out (held by clips ) disc. elec. wires from heater controls , fan, etc. four screws hold radio in place remove & pull radio. takes less than ten min. to do . good luck on your mod.
#4