i have a dodge 1997 caravan these are the codes because my service engine light came on 1775,p1784,p0740,p0732,p0700, and then i got these fault codes not sure what they mean from this transmission guy,24,38,75,35,36,52... what do i do? what should i fix being low income and i have to drive to work three times a day about a 2 hour drive to next city..help please..

 

Okay P1775 is solenoid latched in TCC, There wasn't any P1784, but there is a 1684 battery disconnected, P0740 is a torque converter code, P0732 gear ratio error in 2nd gear, and P0700 is to let you know there is a internal fault in the controller.

24= LR pressure circuit, 38=torque converter,35=loss of prime,36=fault after shift, 52= gear ratio error in 2nd, and 75= high temp operation.

 

Hi everybody! I would like to know how you fix the thread problem, my Liberty 2005 has the same: rough 2-1 downshift and code P1775 someguys told me was probably the solenoid pack, valve body or the PCM. I change it with no success. thanks!

 

Never heard from the member if the problem was fix. What parts have you you replaced so far.

 

How can I get a copy of the PDF for the diagnostic codes p0700 p1775. I have a 2004 chrysler town and country with the same issue.

 

Hi I need the pdf files mentiond in this thread to fix this problem!

 

I see you ran a reply on error codes p0700 and p1775 you talked about a diagnostic sheet for error codes it is a 2000 dodge grand caravan with the 3.8 liter in it if it matters. thank you Mark.

 

Please send me the PDF also. This happened to my Dodge 2005 Dakota

 

Symptom:
P1775-SOLENOID SWITCH LATCHED IN TCC POSITION
When Monitored and Set Condition:
P1775-SOLENOID SWITCH LATCHED IN TCC POSITION
When Monitored: During an attempted shift into 1st gear.
Set Condition: The code is set if three consecutive unsuccessful attempts are made to get
into first gear in one given key start.
POSSIBLE CAUSES
CHECKING SYMPTOMS AND POSSIBLE CAUSES
LOW BATTERY VOLTAGE CAUSING SYMPTOM
OTHER CODES PRESENT
TRANS CTRL RELAY OUTPUT CKT SHRT TO L-R PRES SW SENSE CKT
TCM L-R PRESSURE SWITCH SENSE INPUT DEFECTIVE
TCM L-R PRESSURE SWITCH STATE READS OPEN
TRANSMISSION SOLENOID PACK DEFECTIVE
INTERMITTENT CODE P1775
VALVE BODY ENGINE IDLE TOO HIGH
VALVE BODY SOLENOID SWITCH STUCK IN LOCK-UP
TEST ACTION APPLICABILITY
397 Check the Global Good Trip Counter.
Is the Global Good Trip counter 3 or less ?
All
Yes ® Go To 399
No ® Go To 398
398 Write down and record all DTC’s and one trip failures.
With the DRB, erase DTC’s.
Follow the instructions below, and try to set the code.
Code P1775 - Drive in 2nd gear, then apply the Brakes until a 2-1 downshift occurs.
Do this at least 3 times.
Did the erased DTC come back ?
All
Yes ® Go To 399
No ® Go To 408
399 Connect the DRB to the 16-way Data Link Connector.
Check connectors - Clean / repair as necessary.
Perform DRB SHIFT LEVER System Test.
Did the test pass ?
All
Yes ® Go To 400
No ® Refer to symptom ADDITIONAL CHECK SHIFTER SIGNAL
(P0705) in the TRANSMISSION category.
400 Start Engine and note idle speed using the DRB.
Is the idle speed above 1100 RPM?
All
Yes ® Repair Engine idle speed too high.
Perform Transaxle 41AE/TE Verification TEST VER-1A
No ® Go To 401
401 Engine Off. Install a 0 to 300 psi gauge on the L-R pressure port.
Start Engine in Park.
Is pressure above 20 psi?
All
Yes ® Go To 402
No ® Go To 405
402 Using the DRB, read the L-R Pressure Switch State.
Does the L-R Pressure Switch state read OPEN ?
All
Yes ® Go To 403
No ® Perform test(s) for other DTCs, if applicable. Perform Loss of
Prime test if no other DTC’s are present.
Perform Transaxle 41AE/TE Verification TEST VER-1A
403 Key Off, disconnect Solenoid Pack Connector.
Check connectors - Clean / repair as necessary.
Measure the resistance between the Transmission Control Relay Output Circuit
(Switched B+) and the L-R Pressure Switch Sense Circuit.
Is the resistance below 5.0 ohms?
All
Yes ® Repair the Transmission Control Relay Output Circuit shorted to
L-R Pressure Switch Sense Circuit.
Perform Transaxle 41AE/TE Verification TEST VER-1A
No ® Go To 404
TEST ACTION APPLICABILITY
404 Replace Solenoid Pack.
Start Engine in Park.
Using the DRB, read the L-R Pressure Switch state.
Does the L-R Pressure Switch state read CLOSED ?
All
Yes ® Test Complete.
No ® Replace TCM
Perform Transaxle 41AE/TE Verification TEST VER-1A
405 Apply brakes firmly.
Place Gear Select Lever in Reverse position.
Does reverse engage?
All
Yes ® Go To 406
No ® Go To 407
406 Check the Solenoid Switch Valve for proper operation.
Does it move back and forth freely ?
All
Yes ® Replace Solenoid Pack.
Perform Transaxle 41AE/TE Verification TEST VER-1A
No ® Repair or recondition VALVE BODY. (SOLENOID SWITCH
VALVE stuck in LU position)
Perform Transaxle 41AE/TE Verification TEST VER-1A
407 Read the DRB for other codes present.
Are any other codes present ?
All
Yes ® Perform appropriate tests for other Codes.
Perform Transaxle 41AE/TE Verification TEST VER-1A
No ® Refer to symptom ADDITIONAL LOSS OF PRIME (P1791) in the
TRANSMISSION category.
408 Inspect the following for pushed out terminals or flared connections: - Engine gnd
connections - TCM grounds (pins 53 and 57) - TCM battery feed pin 56 - Power feed
to Trans Ctrl Rly from the EATX fuse in the PDC - TCM Fused Ignition Sw Output
pin 11
If the above connections are in good condition, carefully inspect the TCM 60-WAY
Terminal # 15, and 50 for pushed out terminals or other damage. Also, check to make
sure that they are not shorted together.
Was a defective condition found?
All
Yes ® Repair as necessary.
Perform Transaxle 41AE/TE Verification TEST VER-1A
No ® Go To 409
TEST ACTION APPLICABILITY
409 Connect the DRB to the Data Link Connector. Reconnect any disconnected components.
With the DRB, erase all Trouble Codes and set the Global Good Trip Counter
equal to zero.
With the DRB, display Transmission temperature. Start and run the Engine until the
Transmission is HOT (above 110 deg. F) CHECK THE TRANSAXLE FLUID.
ADJUST IF NECESSARY.
Road test the vehicle. With the DRB, monitor the Engine RPM. Make 15 to 20
1-2,2-3,3-4 upshifts. Perform these shifts from a standing start to 45 MPH with a
constant throttle opening of 20 to 25 degrees.
Below 25 MPH, make 5 to 8 wide open throttle kickdowns to 1st gear. Allow at least
5 seconds each in 2nd and 3rd gear between each kickdown.
If the vehicle is equipped with AutoStick, place the shift lever in the AutoStick
position and perform a complete upshift and downshift sequence.
Did the Transaxle function properly during the road test ?
All
Yes ® Test Complete.
No ® Go To 410
410 Note: Low Battery voltage can cause many of the non-DTC Symptoms (denoted by a
preceding asterisk) listed in the Symptoms List.
Check the Battery voltage with a voltmeter.
Is the Battery voltage low ?
All
Yes ® Repair low Battery voltage as necessary and verify that original
symptom exists before proceeding with any non-DTC (Symptoms
preceeded with an asterisk) symptom repairs.
Perform Transaxle 41 TE/AE Verification TEST VER-1A
No ® If Battery voltage is OK, refer to Symptoms List for problems
related to Transmission and select the Non-DTC Symptom (preceeded
with an asterisk) from the Symptoms List that best
describes the existing problem.
Perform Transaxle 41 TE/AE Verification TEST VER-1A
165
TRANSMISSION
P1775-SOLENOID SWITCH LATCHED IN TCC POSITION

 

I'm having the same problems with my 2001Dodge Grand Caravan as everybody here on this post.I've the same codes like P0732,P01775,P0731,P0720,P0700,P0455 &P0500..I would very much appreciate having a copy of the code sheet ..Any and all information is much appreciated.My 2001 Dodge Grand Caravan is a 3.8L.And 6 cylinder.'It's a 2 W/D. I think that's about all the info needed,if more is needed PLEASE let me know..I'm a new member,just regirstered today after reading all the good info provided here.Thank you,inadvance for your time & help in repairing my van.
Queenannie68