97 Caravan starts and runs a few seconds then shuts off, security system issue?
#11
A start and die is usually caused by the theft system, make sure you check that first before going after the cluster.
INSTRUMENT CLUSTER BEZEL
REMOVAL
REMOVAL
INSTRUMENT CLUSTER BEZEL
REMOVAL
- Remove steering column cover.
- Remove over steering column bezel
- Remove left end cover.
- Remove screw at left end of cluster bezel and headlamp switch.
- Remove screws holding cluster bezel to instrument panel from each side of steering column.
- Disconnect clip holding cluster bezel to instrument panel from above right vent louver.
- Separate cluster bezel from instrument panel.
- Disconnect wire connectors from back of the bezel.
- Connect wire connectors into back of the bezel.
- Place cluster bezel in position on instrument panel. Use care not to place hands on louvers.
- Connect clips to hold cluster bezel to instrument panel. Use care not to add pressure on the A/C louvers to seat the cluster bezel clips.
- Install screws to hold cluster bezel to instrument panel on each side of steering column.
- Install screw at left end of cluster bezel and headlamp switch.
- Install left end cover.
- Install over steering column bezel.
- Install lower steering column cover.
REMOVAL
- Remove instrument cluster bezel
- Remove screws holding instrument cluster to instrument panel.
- Rotate top of cluster outward.
- Remove instrument cluster from instrument panel.
- Disconnect wire connector from back of instrument cluster.
- Remove instrument cluster.
- Place instrument cluster in instrument panel, bottom first.
- Connect wire connector into back of instrument cluster.
- Position instrument cluster in instrument panel.
- Install instrument cluster mounting screws to instrument panel.
- Install instrument cluster bezel.