When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Dodge CaravanThe Dodge Caravan is the best selling mini van from Dodge. How many Dodge Caravan owners here at DodgeForum.com would agree? Discuss it now!
I fixed the harness issue, please, the attachments.
The board was under fuse panel.
The following abs codes were scanned:
21 Valve Power Feed failure
24 System under voltage
26 Bus communication failure
Thank you so much for this simple solution. You saved me time and made me some money. I moved the battery out of the way and flipped up the fuse panel under the hood and it was exactly like your picture.
Might be a temp fix but if your connector looks like that you really need to change it. It appears to be on the fuse box (PDC/IPM) correct? Change the box. Try junkyards or EBay for a cheaper option. Coat with dielectric grease.
Might be a temp fix but if your connector looks like that you really need to change it. It appears to be on the fuse box (PDC/IPM) correct? Change the box. Try junkyards or EBay for a cheaper option. Coat with dielectric grease.
I took out each individual wire from the connector, cut the rotten ends off and replaced/repaired each one then soldered back to the wires after cutting off the rotten ends. I cleaned the plastic housing and it's better than new. It's a permanent fix because the solder will not rot.
I repaired two corroded ends like above, but my abs and brake lights remain lit.
does this mean that my abs module is bad?
2005 t and c
No, it does NOT. you have to pull the code from the ABS module with a Scanner. there are no other way to test it. And throwing a $400 part in and pray it will work is not the way to go.
I have 04 Caravan,same problem - changed parking brake switch(~6$),left negative batery cable loose for 6 weeks(have spare car) and now there is no light on my dash(ABS was on for 2 years)
sorry to be more specific, i am getting a code:
21 Valve Power Feed failure
I fixed the endes in fuse box like above, is there any other way to determine the cause of abs/brake lights on?