[4th Gen : 01-07]: Accessing inside 07 quarter panel to pop out dent.
#1
Accessing inside 07 quarter panel to pop out dent.
Hi Folks;
New here and would appreciate a bit of help. Just bought an 07 for my wife. It was a local rural dealer customer shuttle and has been very well maintained, and works great. It does have a dent on the rear quarter panel (passenger side) that has no torn metal and I am sure can be "popped" back from the inside. I have owners manual as well as service manual but neither of these tell me specifically what I need to remove, step by step, to access inside of rear fender. This van is shorter wheel base 7 passenger without stow and go seating. If anybody has done same and can tell me what I need to remove, and in correct order, would very much appreciate same. Thanks again.
New here and would appreciate a bit of help. Just bought an 07 for my wife. It was a local rural dealer customer shuttle and has been very well maintained, and works great. It does have a dent on the rear quarter panel (passenger side) that has no torn metal and I am sure can be "popped" back from the inside. I have owners manual as well as service manual but neither of these tell me specifically what I need to remove, step by step, to access inside of rear fender. This van is shorter wheel base 7 passenger without stow and go seating. If anybody has done same and can tell me what I need to remove, and in correct order, would very much appreciate same. Thanks again.