Go Back   DodgeForum.com > Dodge Trucks > Dodge Ram > Dodge Cummins Diesel
Sign in using an external account
Register Forgot Password?

Dodge Cummins Diesel Discuss all generations of Cummins Diesel powered Ram's within Dodge Diesel Forum.

Reply
 
 
 
 
Thread Tools Search this Thread
  #1  
Old 04-03-2008, 12:02 PM
austin austin is offline
Veteran
Garage is empty, add now
 
Join Date: Oct 2006
Location:
Posts: 360
Default NEED HELP, trucks in the shop!

Well after my truck being in the dealership for 3 days now here is what they said.

" sand in the fuel tank. transfer pump is shot. Fuel rod needs to be replaced(wtf is a fuel rod?). The tranny fluid needs to be changed and might have water in it. Tranfer case, and diffs need to have their fluid changed(which is normal at 65000 miles)"

GEEZE!! My truck ran perfect before goodyear had it... and I had this dealership do a 150 point inspection before I bought the truck and everything was perfect.

What is a fuel rod? and how exactly can sand get in the fuel tank? Must be the previous owner because I haven't gone through any sand at all.

Thanks!
Austin
This ad is not displayed to registered and logged-in members.
Register your free account today and become a member on Dodge Forums!
__________________
04 Ram 2500 CTD
Level kit, 35s, Ranch Hand bumper, CB Radio, chest toolbox
Soon to come: muffler delete, Ranch Hand rear, Edge, 2 12" CVRs
Reply With Quote
  #2  
Old 04-03-2008, 12:05 PM
Jr. Mechanic Jr. Mechanic is offline
Grand Champion
Garage is empty, add now
 
Join Date: Jan 2007
Vehicle: 1993 Jeep ZJ, 1983 Camaro Z28
Location: Lima, Ohio
Posts: 5,525
Default RE: NEED HELP, trucks in the shop!

How the hell do you get sand in the fuel tank?? What was the truck doing when you took it in?
__________________

1983 Z28, 350 4 bolt, Vortec heads, XE268H cam, Weiand Stealth intake, Street Avenger 670, Edelbrock Street Pump, Spohn steering, UMI SFC's, UMI wonderbar, built 700R4, Summit Racing 2600 stall converter, Hedman 68478's, Too much to list
Reply With Quote
  #3  
Old 04-03-2008, 12:31 PM
dirtydodge02 dirtydodge02 is offline
Banned
Garage is empty, add now
 
Join Date: Aug 2006
Vehicle: 2005 Ram 3500 QCLB
Location: Casper, Wyoming
Posts: 1,184
Default RE: NEED HELP, trucks in the shop!

I sense foul play Batman... Does your gas cap lock?

Reply With Quote
  #4  
Old 04-03-2008, 01:38 PM
Mayfair's Avatar
Mayfair Mayfair is offline
Legend
Garage is empty, add now
 
Join Date: Aug 2006
Location: 100% Heaven Sent
Posts: 8,530
Default RE: NEED HELP, trucks in the shop!

Sounds like someone is getting hosed




At what point is your Pop gonna step in and take the reigns of this monster. This tale of woes is spinning out of control.
__________________
1998.5 Ram Cummins 24 valve turbo diesel
Reply With Quote
  #5  
Old 04-03-2008, 08:48 PM
JimmyDiablo JimmyDiablo is offline
Champion
Garage is empty, add now
 
Join Date: Dec 2006
Vehicle: Born and raised in Los Angeles, Moved to Arizona, will never go back
Location: Avondale, Az
Posts: 4,357
Default RE: NEED HELP, trucks in the shop!

Did the previous owner know that our trucks run on fuel, oil and bio? Not sand!!!
__________________
Reply With Quote
  #6  
Old 04-03-2008, 10:21 PM
Drew Drew is offline
Professional
Garage is empty, add now
 
Join Date: Aug 2004
Location: 33.43.342, 84.21.602
Posts: 117
Send a message via ICQ to Drew Send a message via AIM to Drew Send a message via Yahoo to Drew
Default RE: NEED HELP, trucks in the shop!

if your truck is able to run. . .get it now and take it somewhere else. . .you walk in and they are seeing dollar signs
__________________

4/28/07 392hp 716tq on the stock clutch
10/20/07 425hp 798 still on the stock clutch
BIG THANKS to David and the guy's at James O'neal Dodge.
YOU GUY'S ROC
Reply With Quote
  #7  
Old 04-03-2008, 10:50 PM
burban2002 burban2002 is offline
Veteran
Garage is empty, add now
 
Join Date: Sep 2007
Location:
Posts: 405
Default RE: NEED HELP, trucks in the shop!

I thought you trusted this dealer? Maybe back to goodyear!
Reply With Quote
  #8  
Old 04-03-2008, 11:35 PM
austin austin is offline
Veteran
Garage is empty, add now
 
Join Date: Oct 2006
Location:
Posts: 360
Default RE: NEED HELP, trucks in the shop!

Well finally got to talk to the guy in person, and see my truck. Yes, I do trust this dealership. I have been with them for 2 years and they have yet to screw me over. I was just really nervous this time around...

The fuel pump is bad now. If yall recall the ranch hand was dented in the front pretty good, that jar shortened the life of it a lot. They are relocating the fuel pump into the gas tank so basicly I wont have to worry about the fuel pump for a long time he said! Every 03-05 Ram that has the fuel pump mounted the engine they are relocating when it goes bad. They are not charging me for labor on that either. Fuel pump is $1100 though...

The "fuel rod" is sticking apparently... you will read why in a minute. I noticed on my truck when I go mudding the engine doesn't really want to slow down in the RPMs. Since it was sticking the RPMs would stay up a little bit longer than they should. Not that much of a problem, yet, but I decided to get it fixed up anyway.

THE CAUSE OF ALL THESE PROBLEMS: City diesel. I always fill up in Coppell(city where I live, outside of Dallas) When I get back from Oklahoma every week. Coppell doesn't have many diesel trucks at all! So they fuel sits in those tanks for a long time. I go there because it is about 15 cents cheaper than everywhere else.
So, that is where all the grime came from. The tech recommended filling up on the way to OK at a truck stop, since they get new fuel a lot often than my city does. Thus, less contaminated.

They said they see this quite often on the trucks they have. People who fill up in the city get all the bad crap at the bottom of the tank. The 6.7L get it often here with all there high tech crap they got on it.

The computer was messed up because the chip that is on the truck is only water resistant. It dried out, and the computer went back to normal. The dealer is going to clear all the codes, free of charge. If no codes pop back up then I am in the clear! I will seal the chip up with RTV sealent this weekend.

So ending the story, it wasn't good years fault. It wasn't my fault either, or going mudding(to an extent I think ) Things like this just happen it seems. I see it on the forum often also, so I know it isn't just me that had this luck. Total cost is $2300 and the truck will be ready tomorrow(friday). Yeah that cost sucks... But knowing my truck is reliable, and having a free warrenty on everything they did the past couple of days, is worth it IMO.

I talked to Goodyear. They quoted me over $3000 to do everything that the dealership is doing. The dealer is cutting me $300 off the price(they are not charging me labor on A LOT of things), and they are going the extra mile with giving me a free 30 day warrenty on all their parts they replaced, and relocating the fuel filter. So to me I got a good deal. My dad agreed to split the cost with me, as long as he can bug me for buying a used truck [:@]( I hate when he does that! haha)
__________________
04 Ram 2500 CTD
Level kit, 35s, Ranch Hand bumper, CB Radio, chest toolbox
Soon to come: muffler delete, Ranch Hand rear, Edge, 2 12" CVRs
Reply With Quote
  #9  
Old 04-04-2008, 07:16 AM
Drew Drew is offline
Professional
Garage is empty, add now
 
Join Date: Aug 2004
Location: 33.43.342, 84.21.602
Posts: 117
Send a message via ICQ to Drew Send a message via AIM to Drew Send a message via Yahoo to Drew
Default RE: NEED HELP, trucks in the shop!

it's not the fuel rod. . .it is the FCA(Fuel Control Acutor) it lives on the back of the CP3 and controlls the rate of fuel flowing through it to the fuel rail

also, I steer clear of the mom and pop stores for diesel all that I can. they dont have a high turn over and crud will get in the tank.

and the last thing, believe it or not, the intank pump is the same POS Carter pump that is mounted on the back side of the filter, only in a different houseing so it will go in the tank. Mine is still working, amazing enough, but I do know it will get replaced with something much better.
__________________

4/28/07 392hp 716tq on the stock clutch
10/20/07 425hp 798 still on the stock clutch
BIG THANKS to David and the guy's at James O'neal Dodge.
YOU GUY'S ROC
Reply With Quote
  #10  
Old 04-04-2008, 11:33 AM
austin austin is offline
Veteran
Garage is empty, add now
 
Join Date: Oct 2006
Location:
Posts: 360
Default RE: NEED HELP, trucks in the shop!

Well my truck has been in the shop all week. I NEED it this weekend. If it was up to me I would have gotten an aftermarket pump. Since I just needed it out of the shop, and don't plan on having this truck for over 200,000 miles I think I will be ok. The only power upgrade I am going to put is the Edge... So stock will be fine

I am picking the truck up today. I will let yall know how it goes!
__________________
04 Ram 2500 CTD
Level kit, 35s, Ranch Hand bumper, CB Radio, chest toolbox
Soon to come: muffler delete, Ranch Hand rear, Edge, 2 12" CVRs
Reply With Quote
Old 04-04-2008, 11:33 AM
 
 
 
Reply



Tags
5183245aa, 68003869aa, 68003870aa, cummins, dodge, fuel, number, part, pump

Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off
Forum Jump

Advertising

Featured Sponsors
Vendor Directory
Our Sponsors
All times are GMT -4. The time now is 04:54 AM.

© Internet Brands, Inc.

Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2012, Jelsoft Enterprises Ltd.
Search Engine Friendly URLs by vBSEO 3.5.2

Contact Details & Emails