I was looking to put some 33 12.50 on my 06 and was just wantint to know if any of you have done this. Did you have to put the 2 inch leveling kit in the front? Or if they cleared without it. If i have to lift it i will prolly go ahead and lift it enough to put 35 under it. Thanks for any input...

STUCK

 

I have the 2" lift w/ 35 procomp and they rub a little on the a-arms inside.

 

No worries, the 33's will fit without the leveling kit.

If you go with the 35's most suggest a lift to clear the tire well but a leveling kit (or lift) is not likely to solve the rub on the control arms.

Most still report this close to full clock of the steering wheel (left or right). But then again most dont seem to mind too much.

If it is really a concern you can buy aftermarket control arms but they are pricey!

 

the only way to get rid of the rubbing is go with a a offset rim or a smaller tire.i have a 2 inch leveling kit with 315/70/17 and i don't rub with a offset rim.i think its 40 mm.i can't remember.

 

305/55-20 Nitto Grapplers (roughly 32.5"s)
I had to pull and zip-tie the inside fenders back just alittle on the backside of the fenderwell
rims are 20X8.5 with a 0 offset.
I did a ton of research before I bought these wheels...just got them last Thursday. I was told if I was not going to raise the truck I need a 0 to + 10-12 offset. If the truck was lifted then I could go with a (-) neg. offset.....allowing the lip to be deeper, therefore, the face of the rim sits deeper inside

 

More

 

What is the load rating on the Nittos?

 

3195lbs

 

Sorry, I just wanted to see how this posting thing works

 

i got 33 12.50s and they rub when i turn but i have 17X10 rims also. i have a 2" leveling kit i need to get put on