P0973 p2769 codes, in limp mode-help!!
#1
P0973 p2769 codes, in limp mode-help!!
Good Morning !!
I have a 2004 dodge 2500 with a cummins. Having a rough time getting to the bottom of my electrical issues!
I notice this problem when truck goes into limp mode and set the two codes for low/ lose voltage or ground.. P0973 ..I have installed two new battery's and checked and cleaned all contacts and connections .. i checked the transmission control relay circuit and checked connections and wires.. The three bigger connections in the top of trans two had fuel in connections and I found melted wires in the harness that leads towards trans... I checked the fuse box , Ecu pins , connectors .. Some times the speedo cuts in and out .. Some times the code will clear other times not .. Any help or suggestions would be great thanks
I have a 2004 dodge 2500 with a cummins. Having a rough time getting to the bottom of my electrical issues!
I notice this problem when truck goes into limp mode and set the two codes for low/ lose voltage or ground.. P0973 ..I have installed two new battery's and checked and cleaned all contacts and connections .. i checked the transmission control relay circuit and checked connections and wires.. The three bigger connections in the top of trans two had fuel in connections and I found melted wires in the harness that leads towards trans... I checked the fuse box , Ecu pins , connectors .. Some times the speedo cuts in and out .. Some times the code will clear other times not .. Any help or suggestions would be great thanks
#2