04 status 2.4L boggs down during accel
#1
04 status 2.4L boggs down during accel
idles great but has a hesitation during acceleration in gear and in park no codes poping up. thought it was the fuelpump/filter replaced still the same. ive replaced the MAP sencer,PVC and no change. recently changed coil and plugs. planning on changing crank and cam shaft postion sencer unless better idea/solution comes up.
Trending Topics
#8
I have a 2004 Stratus 2.4L SOHC mitsubishi G engine, the car runs great starts fine but if I quickly press gas it will not take gas! If I drive it normal and slowly accelerate It does fine, I put it in neutral and push gas to the floor and it acts like it is idling but the RPM pulse from idle to + 300 rpm,s it is like I am giving it a little gas but I am not! not getting any check engine light no codes!! I took throttle body off cleaned it good, I checked voltage on TPS all was good nice steady voltage as I increase the throttle .6 volts closed 5.0 volts wide open. I checked Ohms on fuel injectors all within specs. new plug wires, coils, plugs, I put a new head and timing belt on it two years ago. I checked all vacuums lines seem fine. I am at a loss
Thanks
Thanks
#9
I have a 2004 Stratus 2.4L SOHC mitsubishi G engine, the car runs great starts fine but if I quickly press gas it will not take gas! If I drive it normal and slowly accelerate It does fine, I put it in neutral and push gas to the floor and it acts like it is idling but the RPM pulse from idle to + 300 rpm,s it is like I am giving it a little gas but I am not! not getting any check engine light no codes!! I took throttle body off cleaned it good, I checked voltage on TPS all was good nice steady voltage as I increase the throttle .6 volts closed 5.0 volts wide open. I checked Ohms on fuel injectors all within specs. new plug wires, coils, plugs, I put a new head and timing belt on it two years ago. I checked all vacuums lines seem fine. I am at a loss
Thanks
Thanks