Dr Donut

This is Chris McKenna here. I hope you did not go with those fuel rails. I have been trying to get a hold of the person I had sent a message to a while back regarding custom made fuel rails.

Those fuel rails were fire hazards and were junk. The design was bad, the machining tolerances were out and the mounting system was not able to withstand vibration.

- issues were too numerous to list but, all leaked fuel like hell and, I called them and told them that someone over there needs to wake up and redesign the rails and TEST them before shipping any more out.

The main issues were:

- where the lines connect: the wrench fitting is under a cover and unaccessible thus making it impossible to tighten the fittings thus resulting in leaks.

The only way to tighten them was to remove the cover on the fitting end on the fuel rail by removal of a fastener. This was a HUGE pain to do. If you lose the little allen screw, your F-d as there's nothing to secure the fitting to the rails and since they used an o-ring fitting- it will just pop under pressure and you will have an engine fire.

Next issue:
- the mounts suck. The mounts are ok by idea but, do not hold up under vibration thus causing the entire fuel rail to pop off the injectors at the o-ring junction. Fuel everywhere and once again, engine bay fire for sure as a result of gas spilling on the hot engine or spark ignition.

If your still looking or even still interested in new fuel rails, I have a new supplier for top quality, CNC precision machined rails. I am designing the mounting system and having an aerospace machinist fab up the mounts.

These are going to be much better and much much safer. You let me know if your interested.

Chris M
Engineer

my rollbar is a grizzly brand u can buy one that looks like it i dont remember the brad of it though at autozone for like 1,800.00 and some change because you have to order two of each