Been awhile since I've been here...
Anyway's, I need a rear sump oil pan, pickup tube and dipstick. I'm will to trade if you'd like. My 318 came out of a 5th Ave so it's got the center hump setup right now.
I'm also looking for a set of 92-93 5.2 exhaust manifolds for it. Would like to find the corresponding Y pipe too for now from a Dakota. Part #'s I believe are 53006617- DS & 53006618- PS.

If interested I'm willing to trade the old exhaust manifolds too, one side dumps in the middle and the other is slightly offset towards the rear of the engine.

Forgot to mention earlier, Im also looking for a 4BBL carb and intake. I don't care if it's an old aftermarket set up, or a stock set up from the 70's-80's from a 318-340-360.

 

Really? Nothing?!... These shouldn't be too hard to find! especially on Dodge Forum... I know it's older but...
I'd get most at the JY, but they told me no for each thing, and there not open when I get off work, so I can't pull what they're too lazy to pull. Carb's there are also seemingly non existent too...

oh-Also now looking for 1st gen 2WD Dakota V8 front coil springs!

 

Sadly my stock exhaust manifolds ended up in the dumpster when I fitted LT headers.
Otherwise they'd be yours for the price of shipping.
No help, I know... but now at least you have a response to your thread.

 

Bump... still wanted...

 

Would the exhaust manifolds from a 1997 Ram 5.9 do you any good? I have a pair of those.

 

Set of Exhaust Manifolds found!
Still looking for everything else!

Rear Sump Oil Pan-Pickup Tube-Dipstick
4BBL Carb+Intake
1'st gen Dakota front Coil Springs off V8 2wd truck

5th Ave/Diplomat/Fury exhaust manifolds now for sale! Very solid-No cracks, ect.


(Hey Mod's, can ya change the title of this thread? Take out the"5.2 exhaust manifolds" and put in "4BBL Carb+Intake")

 

I'm putting headers on my 318 Magnum RC after Christmas? Will the factory manifolds off of it work for ya?

 

They would have, but I've got a set now. Only currently looking for what's listed in my last post.

 

I have an Edelbrock 800 CFM square bore manual choke for sale that is off my Coronet R/T. I used it for about five years and I forget the part number stamped on the side of it. My engine (440 cid) is being rebuilt and it is sitting at the machine shop with the intake. I do not know if it will fit a 318/340/340 though.

 

^I honestly dont think it woud fit.^ That and 800CFM is way to big for a 318. I should probably stick to a 600 or lower.


Thanks Dirtydog for changing the title!