DodgeForum.com

1st Gen Ram Tech '93 & older Rams: This section is for TECHNICAL discussions only, that involve 1993 Rams and older. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

1993 318

Thread Tools
 
Search this Thread
 
  #1  
Old 05-10-2012, 04:52 PM
chuck230's Avatar
chuck230
chuck230 is offline
New Member
Thread Starter
Join Date: May 2012
Location: New York
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default 1993 318
i need help. i am not getting any spark and all the wires and coil are okay. the distributor is also good along with a new cap and rotor. is there anything else i could check to find out what else is wrong
 
Reply Like
  #2  
Old 05-10-2012, 05:29 PM
crazzywolfie's Avatar
crazzywolfie
crazzywolfie is offline
Legend
Join Date: Jun 2009
Location: orangeville ontario
Posts: 8,023
Received 71 Likes on 67 Posts
Default
can you hear the fuel pump turn on when you turn the key on? if not then you may have a bad asd relay. if you can hear it turn on you may have a bad crank position sensor.
 
Reply Like
  #3  
Old 05-10-2012, 06:03 PM
chuck230's Avatar
chuck230
chuck230 is offline
New Member
Thread Starter
Join Date: May 2012
Location: New York
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default
Originally Posted by crazzywolfie
can you hear the fuel pump turn on when you turn the key on? if not then you may have a bad asd relay. if you can hear it turn on you may have a bad crank position sensor.
Where is the asd relay?. is there any way to check the asd relay or crank positioning sensor?
 
Reply Like
  #4  
Old 05-10-2012, 06:14 PM
crazzywolfie's Avatar
crazzywolfie
crazzywolfie is offline
Legend
Join Date: Jun 2009
Location: orangeville ontario
Posts: 8,023
Received 71 Likes on 67 Posts
Default
the asd relay should be on the drivers side fender. you might be able to swap it with another relay. this will help you test the asd if you have the tools to
http://autorepair.about.com/library/a/1g/bl860g.htm
 
Reply Like
  #5  
Old 05-31-2012, 08:02 PM
chuck230's Avatar
chuck230
chuck230 is offline
New Member
Thread Starter
Join Date: May 2012
Location: New York
Posts: 4
Likes: 0
Received 0 Likes on 0 Posts
Default
the asd is fine but i am wondering. can i run a ground straight from the battery to the white wire going to the coil. or where is the ecm and how do i check it
 
Reply Like
  #6  
Old 05-31-2012, 08:33 PM
crazzywolfie's Avatar
crazzywolfie
crazzywolfie is offline
Legend
Join Date: Jun 2009
Location: orangeville ontario
Posts: 8,023
Received 71 Likes on 67 Posts
Default
if you have fuel but no spark then it is most likely a bad crank position sensor.
 
Reply Like
Back to Subforum
1st Gen Ram Tech
View Next Unread
1987 D150 wiring diagram?




Advanced Search
Quick Reply: 1993 318


Reply Closed Thread Share
Forum Jump

All times are GMT -4. The time now is 10:26 AM.