Changing out my transfer case selector motor, Any tips from anyone would be helpful!
I'm down to the companion flange and wondering what kind of torque is on it? Also any tricks to get the transfer motor back in and lined up. Then I would like to test it before I put the drive shaft back in. Any help would be appreciated! Thanks
|
Tighten the flange nuts to 90-130 ft pounds.
The motor itself should only go in one way. |
Is that a 29mm nut? The closest I have is an 1" 1/8. My impact does not want to budge it.
|
All times are GMT -4. The time now is 02:51 PM. |
© 2024 MH Sub I, LLC dba Internet Brands