Axle whench size
Anyone know off hand what size socket is required to remove the drive axle hub nut on a 2001 Neon?
|
Somewhere around 26MM I think. Can't remember the exact size.
|
32mm axle nut socket
|
Must be different on the 00-02's then (I do not have a socket that big, but got mine off with the correct size one), or I'm thinking of the wrong thing.
|
axel nut
32mm sounds about right, I think I only have a 30mm so will have to pick one up.
Thanks |
Originally Posted by darthroush
(Post 1787569)
Must be different on the 00-02's then (I do not have a socket that big, but got mine off with the correct size one), or I'm thinking of the wrong thing.
|
Wheel Bearing done
Thanks guys the front axel nut is 32mm. and back is 30mm.
I did one front wheel bearing. both rotors and pads plus added grease nipples to the ball joints. Another point is the ball joint grease nipples "ZERK" fittings are 1/4" x 28 taper thread, 6mm screw in but won't tighten. NOTE: if you add these do not over grease one or two shots every 5000-10000km is lots. To do the bearing, I picked up a 12 ton press at Princess Auto on sale for $129.00CDN, I would have paid more that that in shop labor. |
The deep socket size to remove axle nut in the rear is a 30 mm. I know for sure because I literally just got done doing one
|
All times are GMT -4. The time now is 07:19 PM. |
© 2024 MH Sub I, LLC dba Internet Brands