What Did You Do To Your 2ND GEN RAM Today?
#6733
#6734
#6735
installed my hughes underdrive crank puleey tonight.
pulley was an easy install, but the belt...thats a whole nother issue.
i had to bypass my facory a/c compressor last saummer because the bearing went, so i used a 90" belt to bypass it, so i had no clue what size belt i needed.
well it took 2 seperate trips to advance to get the right belt.
the correct belt size is 87.5" 875k6 is the part number. for a truck without the a/c bypassed it will be a 95" belt and the part number is 950k7 so you will need a belt 2.5" shorter.
so far i have noticed a slight improvement on throttle response, and takeoff is better, and my voltage is under 14v at idle, but comes back after you step on the gas.
pulley was an easy install, but the belt...thats a whole nother issue.
i had to bypass my facory a/c compressor last saummer because the bearing went, so i used a 90" belt to bypass it, so i had no clue what size belt i needed.
well it took 2 seperate trips to advance to get the right belt.
the correct belt size is 87.5" 875k6 is the part number. for a truck without the a/c bypassed it will be a 95" belt and the part number is 950k7 so you will need a belt 2.5" shorter.
so far i have noticed a slight improvement on throttle response, and takeoff is better, and my voltage is under 14v at idle, but comes back after you step on the gas.
#6736
#6737
#6739
The hub buster. Found it amusing. Does it work like the video, don't know.
http://youtu.be/G4pygRExlus
http://youtu.be/G4pygRExlus
#6740