|
Ham Bone's (not so) secret thread of auto to manual swap.
3 Attachment(s)
This happened today.
Attachment 32881 Attachment 32882 Attachment 32883 Didn't take a picture of the bellhousing for some reason. |
Wow! Your Trans FELL OUT? What were you DOING????? :D
Manual trans conversion? |
I was trying to replace the clutches in my auto! I think the parts store gave me the wrong part...... :D
|
I like shiny parts :) Second pic is my fav
|
Looks good so far! I may 6 speed swap my Hemi at some point down the road a bit...
|
Was that an NV or had they switched back to the getrags at that point?
|
Nice! When is the manual trans going in?
|
Originally Posted by Ham Bone
(Post 3226280)
Was that an NV or had they switched back to the getrags at that point?
|
What's taking so long! Haha. Is this the correct pilot bearing? I want to get the right one.
http://www.factorychryslerparts.com/...3009180AB.html |
I will consult my parts list. you def need the sleeve.
Trans when in today The bellhousing to trans bolts are 12.5 x 1.75 x 45mm. Terrible weather hindered my progress today. looks to suck tomrorrow too. Had to swap my input shaft in the t case to 29 spline. Can't get the thing to go into 2wd now. I have N, 4hi, and 4lo. But no 2wd. SucKs. Clutch linkage is installed. All that's left is pedals and the t case, xmemeber Ok. Fixed the t case. The oil pump rod was flopping around. I put it On Correctly this time. Have 2wd. I put the t case And read ds in. It fit with no modifications. But it is about an inch shorter. Should be ok for a little while. No pictures. It's cold, windy, and snow/ice on the ground. |
| All times are GMT -4. The time now is 06:17 PM. |
© 2026 MH Sub I, LLC dba Internet Brands