When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
I blew the differential and pinon and want to swap an 01 junk yard rear end .. I've done wheel bearings brakes water pump control arms etc .. what's the procedure for removing the housing besides remove u Johnny and brake lines? Just the single u bolt on each side and it will drop?
I blew the differential and pinon and want to swap an 01 junk yard rear end .. I've done wheel bearings brakes water pump control arms etc .. what's the procedure for removing the housing besides remove u Johnny and brake lines? Just the single u bolt on each side and it will drop?
Disconnect
Brake lines
Parking brake cables
Wiring (ABS sensor or sensors if 4WALB)
Driveshaft
Remove the u joints and it will move. You WILL NEED new u joints.
02-19-2020, 01:39 PM
Rear axle housing swap
