When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
Ok wasnt sure if complete assembly was available somwhere so i could just plug it in and go also need to find a controller and proper wiring to plug into ruck as my mechanic says it has factory trailer wiring
There should be a four wire connector under the dash somewhere, (there's a pic in the service manual, get one from here.) assuming your truck came with the tow package.
The dealer may actually be able to get you the plug, with the harnesses....... Of course, they will want a pretty penny for it.
There should be a four wire connector under the dash somewhere, (there's a pic in the service manual, get one from here.) assuming your truck came with the tow package.
The dealer may actually be able to get you the plug, with the harnesses....... Of course, they will want a pretty penny for it.
I upgraded to the new 4th gen plug so I have the 4 pin connector to
I upgraded to the new 4th gen plug so I have the 4 pin connector to
Would love to see a photo of what you are talking about here - does the 4th gen connector have the 7 pin setup (like the 2nd gen) and a 4 pin setup with it?
I picked one up at the hardware store...... I just changed out the plug itself though, not the wiring.
I had to do the same thing - the 7 pin connector I had went bad and I noticed that the 7 pin connector is a standard trailer connector available most anywhere, even at WalMart. It's very easy to wire, especially since you have the original connector to use as a guide.