2000 dodge ram won't start
 

took the dodge to get it inspected and on the way home on the passager
side floor it was linking antifreeze so i by passed the heater core.so i could drive the truck
know the truck won't start i have checked fuel pump spark and all of the ground wires. it want's to start but don't have that last ump to get it there
i should mention the engine has been all re done
2000 sport

So right after you did the by pass it would not start? Or did this happen at a latter time?

about a day later it stalled once and i got it running went up the rode with it and had to be towed home haven't been able to get it running sence

I would first make sure you didn't knock a sensor connector loose somewhere, when you were doing the bypass. The crank and cam position sensor elec.plugs are back there in that general location. I don't know what you did or moved around when you did the by pass. So at this point I would lean towards it being something like that for now.

might have bumped the coil wire, its right under the heater hose.

i check and recheck all of the thing you have talked about
still nothing.
it wants to start it just don't have that last ump to get it there:icon_rant:

is the cel on? if yes post codes
post fuel pressure...psi?

do you have 12v at injectors 12v - good spark?

there was one code p-0463

p-0463 - fuel level sensor circuit, high input. check your fuel pressure at the rail, you may have a dead fuel pump.

u can here it come on