When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
so i changed the gaskets on the intake went with parts stor felpro gascket instead of hughes do to money and got it put back together now i have to give it gas to start it and to keep it running and its blowing smoke like a mother out the pipes? and ideas or suggestions?
If you didn't tighten the bolts down in the specific pattern that you're supposed to, the Felpro (or any other) gasket will not seat properly, and you will most likely get leaks. That would cause oil into the cylinders, and if enough oil, smoke.
what color is your smoke ? blueish oil or white-ish?
any coolant in the oil ?
did you belly pan seal up right ?
did you use new intake gaskets ?
did you use rtv on the 4 corners of the intake ?
any problems aligning or torquing the intake ?
12 ft/lbs. is only 144 in/lbs. that isn't much. Overdoing it could have destroyed the gasket and also make it impossible to put even torque across the entire gasket.
hughes told me to do that.
they said to install the gaskets dry and goob some rtv in the corners.
so they lied to one of us.
Very interesting. There was a piece of paper that came with my reinforcement kit, right underneath the torque sequence diagram, that stated not to. I wonder if they changed their policy at some point.