318 uplift..heres where we're at
 

Not a bad day, talked to machine shop (not done yet) and Comp Cams. I must say they are very informative, got the cam and rocker (adjustable, 1:6:1 ratio) information, and the comp cam 20-602-9, check it out. and now that i have that information am able to start specs on heads, course the springs are going to be a bit stiffer, i am guessing 120lbs with 300 over the nose. all is good. but now for the trans.....throwing this question out there" since this is a ECM controlled power horse, with the new motor, ECM is somewhat useless, but will i need to do a few mods to trans for shifting purposes? is this a ECM or vacuum function? any comments, suggestions throw them my way....

Terry (Iggy)