00 1500 tranny removal cant get it out - DodgeForum.com

Go Back  DodgeForum.com > Dodge Trucks > Dodge Ram > 2nd Gen Ram Tech
Reload this Page > 00 1500 tranny removal cant get it out
Notices
2nd Gen Ram Tech 1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.

00 1500 tranny removal cant get it out

Reply

 
 
  #1  
Old 07-05-2017, 05:30 PM
comet424
comet424 is online now
Rookie
Thread Starter
Join Date: Mar 2017
Posts: 50
Default 00 1500 tranny removal cant get it out

I working on a 2000 1500 ram and I cant get the tranny out
I have done every thing I pulled 4 bolts off the back of tranny and the 2 bolts on the front and I cant separate it.. also taken those 4 bolts off the flywheel.. I tied come a long to the tranny and to my backhoe and she still wont come off... whats holding it I see 2 pins I guess do they punch out how you get those out
 
Reply With Quote
  #2  
Old 07-05-2017, 05:57 PM
AtomicDog
AtomicDog is offline
Record Breaker
Join Date: Sep 2012
Location: Central VA
Posts: 1,389
Default

I believe there are a couple of bolts that hold the transmission from the other side. Did you pull the starter? Be sure to pull the starter and check for the bolts that go from the engine into the transmission.
 
Reply With Quote
  #3  
Old 07-05-2017, 06:11 PM
comet424
comet424 is online now
Rookie
Thread Starter
Join Date: Mar 2017
Posts: 50
Default

ya that's what I ment by the 2 bolts from the front one was above the starter and the opposite side... but she wont slide off with using the come a long..... I seen 1 locating pin and I felt for it on the side above starter but I cant get them out if they hammer out I tried heating I tried air chisle to shake nothing working
so wanted to know how many botls hold this thing on
 
Reply With Quote
  #4  
Old 07-05-2017, 08:17 PM
comet424
comet424 is online now
Rookie
Thread Starter
Join Date: Mar 2017
Posts: 50
Default

here is video yes I know crap but best I could do laying under truck

I have the strap tied to my backhoe giving tension on the tranny to pull it out...

you can see 2 bolts removed on the one side and I removed 2 bolts on the right side on the back,,, and then you see in video bolt removed above starter and the one on the other side is removed too
total 6 bolts removed

cant split it
 
Reply With Quote
  #5  
Old 07-05-2017, 08:53 PM
AtomicDog
AtomicDog is offline
Record Breaker
Join Date: Sep 2012
Location: Central VA
Posts: 1,389
Default

Is the starter removed also? It has to come off, If I recall correctly. You likely still have a bolt or two left.
 
Reply With Quote
  #6  
Old 07-05-2017, 09:04 PM
Moparite's Avatar
Moparite
Moparite is offline
Record Breaker
Join Date: Feb 2015
Posts: 2,062
Default

There is a total of 7 (seven) bolts just that hold the bell housing to the back of the block! I think you missed a few.
 
Reply With Quote
  #7  
Old 07-05-2017, 09:27 PM
comet424
comet424 is online now
Rookie
Thread Starter
Join Date: Mar 2017
Posts: 50
Default

in the video you see the fly wheel and the starter removed as I mentioned those are the 2 front bolts.


as for 7 bolts so I have removed six ... 4 in the back where would that one last be
I removed the 2 you see in the video

and the other side was the Dip Stick bolt and the one below it... where would the other bolt be

its awkard to see it..

is there a picture where it shows the bolt holes so I can see
 
Reply With Quote
  #8  
Old 07-05-2017, 09:44 PM
AtomicDog
AtomicDog is offline
Record Breaker
Join Date: Sep 2012
Location: Central VA
Posts: 1,389
Default

Thanks for clarifying that the starter is removed - I could not see that from the video. There is another bolt on the front near the starter - did you remove it? That one tripped me up before.
 
Reply With Quote
  #9  
Old 07-05-2017, 09:44 PM
HeyYou's Avatar
HeyYou
HeyYou is online now
Super Moderator
Join Date: Apr 2010
Location: Clayton MI
Posts: 43,399
Default

I suspect it is at the top of the bellhousing, cleverly concealed somewhere. Might need a mirror to see it....
 
Reply With Quote
  #10  
Old 07-05-2017, 10:09 PM
Moparite's Avatar
Moparite
Moparite is offline
Record Breaker
Join Date: Feb 2015
Posts: 2,062
Default

There is one directly on top in the middle and the others are evenly spaced apart.
 
Reply With Quote
 
 
 


Thread Tools
Search this Thread
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Forum Jump

Featured Sponsors

All times are GMT -4. The time now is 12:46 PM.