When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
2nd Gen Ram Tech1994-2001 Rams: This section is for TECHNICAL discussions only, that involve the 1994 through 2001 Rams. For any non-tech discussions, please direct your attention to the "General discussion/NON-tech" sub sections.
16 inch tires and I'm pulling with it would it be cheaper to buy or just regear I did some research they say my year only came with 3.21 3.55 or 3.92
Not rim size, tire size. They did only come with those gears but you can still regear. You are limited to up to 4.56 as that's the highest for your rear end (Chrysler 9.25) you can go. Regear would be your best bet because it will be new and you'll get 100,000 miles out of your new gears if done correctly. As you take a risk when buying used axles. Just remember the higher you go the lower your top speed will be and the more gas you will use, because your engine will go higher up in the RPMs. If you have stock tire size 4.10s should be fine.